How to reassemble a Tenacious?

CJZ

Gold Member
Joined
Dec 18, 2012
Messages
3,751
I took apart my Tenacious for cleaning, and now can not put it back together. What tools will I need for the job, and how can it be done? Can I mail it to Spyderco for them to do it? (I have a history of screwing things up)
 
Amazing....
All I'm going to say is that if you have a difficult time putting things back together, you really have no need to be taking them apart. If you need to clean your knife, do so with warm soapy water in the kitchen sink, and use keyboard duster cans to remove the water.
 
No worries, CJZ. The worst case scenario is that you send it to Spyderco and pay them a little bit to stick it back together, which is not the end of the world. But you can probably figure it out.
 
That is one of the easiest folder to put together, I'm sure you'll be fine.
 
And yeah, I figured it out. It was just difficult to get all of the washers completely lined up was my problem, especially when you have to take the g10 scales off to do this (I didnt) so basically you had to be here to see how damned difficult it was to put this knife back together.
Im also TERRIBLY sorry for not knowing how to do this.
Apparently everyone including me is supoosed to be an expert.
And now ill receive ridicule for complaining xD
Just saying,
Thanks everyone for the feedback.
 
And yeah, I figured it out. It was just difficult to get all of the washers completely lined up was my problem, especially when you have to take the g10 scales off to do this (I didnt) so basically you had to be here to see how damned difficult it was to put this knife back together.
Just saying,
Thanks everyone for the feedback.
 
Hey, it happens. I usually get a big paper plate and lay all the parts out in a row as I take it apart. Then you just reverse the order to put it back together. I also have a cheap buckshot knife laying in a drawer diss assembled because some idiot (me) decided to take it apart without paying attention to how it goes together. Oops
 
Back
Top