how to tighten blade on sng

R

rourtex23

Joined
Jul 21, 2009
Messages
154
just rcieved the knife there is a lil wobb;e going on what tool do i need to tighten it or what tool could i use to tighten it
 
Send it to Strider, honestly it's quite a struggle to get it off, I drove down and asked them to adjust the pivot and leave the lock tight off.

If you must get it off, you need a soldering iron a removal tool and a 1/8" hex wrench.

Heat for 5-10 monutes then wrench. If it doesn't work more heat.
 
You will need to buy the tool i have a atwood,but there is a better one on the forums someone will post a link..............
 
I don't want to remove it I just want to make it the blade tighter so what tool do I need to do so?
 
rourtex23 said:
anyone know where i could get a tool for it perhaps cheap?
Click to expand...

rourtex23 said:
Does anyone know where I could purchase one of these? Thanks
Click to expand...

Look, you've already been told, and I'll tell you again. It's very hard to adjust the pivot unless the locktite is already removed. Removing it means heating it with a soldering iron for about 15 minutes. It's a serious pain in the ass.

Once you remove the locktite you'll need a spanner wrench. It looks like this: http://www.sears.com/shc/s/p_10153_...Wrenches&psid=NEXTAG01&sid=IDx20070921x00003j

That's probably not the one you need though, I'm not sure of the size.
 
You must log in or register to reply here.
Back
Top