HT Wrap

[jhiggins]

GAH! I just used the last bit I had. I didn't realize I was so low. Has anyone bought some wrap lately? Where is the best price?

 

[Michael J. Spangler]

jeff if you need some i could cut some off and send it to you to hold you over untill you do some shopping around. shoot me an e-mail

 

[jhiggins]

jeff if you need some i could cut some off and send it to you to hold you over untill you do some shopping around. shoot me an e-mail

You are a good one, Mike! I'm okay though. I just need to grab a new roll of it. I always got something else I can do until then.

 

[indian george]

GrasssHoppa should you tell him the price you payed for the rolls???????

 

[Gossman Knives]

Jeff, K&G finishing supply has good prices on stainless wrap.
Scott

 

[McAhron]

Enco has full rolls on sale right now

 

[Michael J. Spangler]

what was the length IG? 50 ft or what?? or was it 50 yards can't remember. but anywho it was $10 per roll. me and IG each got one

 

[jhiggins]

what was the length IG? 50 ft or what?? or was it 50 yards can't remember. but anywho it was $10 per roll. me and IG each got one

YOU SUCK!

do they have any more?

 

[Marcel J.B. Morin]

What Jeff Said.

Marcel

 

[Michael J. Spangler]

all out HAHAHAHAHA
if you guys need some let me know
seriously

 

[howiesatwork]

Major suckage.
If I could get it for $10 for even 50ft, it would be a bargain...
You guys sure it doen't say Reynolds Wrap on the box?

 

[Les Voorhies]

have you tried Turco? I didnt like it when i 1st tried it but i found out from a freind how to use it right and my blades never scale or pit. I don't buy foil anymore.

 

[jhiggins]

I use PBC on my carbon steel blades, but lately I have been doing 154CM and S30V. Some steels require 1900-2000F for austenitizing, so I need the Ticronic wrap. I learned a long time ago that the cheaper iconel wrap won't always do the job over those temps, and will burn a hole into the foil pretty much in the worst possible spot. I think Murphy has something to do with burn-hole location, hehe.

 

[Kit Carson]

Jeff,
I've been using the Enco Ticronic foil for years. Never had a problem with it.
It's on sale right now.

 

[Don Robinson]

Sorry for the crass commercial, guys, but I sell Ticronic foil by the foot on my Knifemaker's Supply web site in case you don't need a full roll.

If you're intetrested, click below.