Hunter in Ash Burl

Sean O'Hare

Sean O'Hare

Joined
Jul 24, 2003
Messages
1,183
Finished this one the other day, it's heading to New York after the Canadian Knifemakers Guild show this weekend.

hunter_ash3.jpg


Specs:

Steel: CPM S30V Satin Finished
Blade Length: 5"
OAL: 9 5/8"
Handle: Stabilized Ash Burl
Bolsters: 416SS Dovertailed
Pins: 5/32 & 1/4" Mosaics

Thanks for looking.

Sean
 
Your knives have sure improved over the last year.

That ash burl looks great. Does this knife have a slight trailing point? Sometimes it is hard to tell from the picture.

Nice sheath.
 
Thanks for the comments guys!

Keith thanks very much. I definitely feel that my knives have improved over the past year. Going to my first show last year and also to Ed's symposium greatly benefited me in terms of improving my knife making. Lots of sharing of techniques and ideas definitely gave me ways to improve my knives.

The tip does curve up slightly but not enough for me to call it a trailing point. It is still very much below the spine where it starts to curve downward.

Take Care,
Sean
 
Thanks Nathan. I definitely like knives that have crisp clean lines to them that can be used with various grips.

Sean
 
You must log in or register to reply here.
Back
Top