I call this one "Fat Bast@#d".

M

MCoughlin

Joined
Feb 1, 2005
Messages
471
Hey guys,

This one is made of cpm154cm. An HRC of 61. Jade G10 handle w/416ss bolsters and mosaic pins. Blade is 2 and 5/8" to bolster and OAL is 6 and 9/16". First time using G10 and I have to say I like it. Just have to put the edge on now. Comments appreciated. Take care.

Mike.
 
I like it. The jade g 10 looks almost translucent, is that how it actually is, or is that an optical illusion?
 
Keep this design. It is very well done and should attract a lot of buyer interest :D . The G-10 handles are a great touch.
 
Great design! one critique is that in the middle pic, it looks like the scales aren't rounded off too much potentially causing hotspots. or maybe it's just the angle...
 
madfast said:
Great design! one critique is that in the middle pic, it looks like the scales aren't rounded off too much potentially causing hotspots. or maybe it's just the angle...
Click to expand...

The translucent scales make it hard to see but I did round off the edges somewhat. I didn't want to go too much because they are only around 1/4" thick on each side and it wouldn't flow with the angles I put on each side on the top of the bolster. The under side or finger grooves are much more rounded off than the top though. For hard use it might create some hot spots but for a small EDC I think it'll be OK. I'll have it so sharp there shouldn't be much resistance with anything I'm cutting anyway...lol.

Mike:D
 
That is a great little knife. You got skills:thumbup:
 
"I smell baaaby...Gimme my baaaby back, baaaby back, baaaby back...Get into my belly!" :D


Great knife!!!!!
 
You must log in or register to reply here.
Back
Top