I thought that the frame lock was putting a lot of pressure on my blade so I took out the frame stop and bent the frame out a little bit. Nothing really happened so I did it again a few more times and the very last time I did it, I went to far and now the frame is bent too far out. It just barley engages the blade and has a lot of vertical blade play and it's really terrible.
In order to fix this, can I just take the knife apart and bend it back? I realized I did something pretty dumb so I want to stop before doing something even worse.
On the plus side, with almost no detent pressure, the knife is super smooth now
In order to fix this, can I just take the knife apart and bend it back? I realized I did something pretty dumb so I want to stop before doing something even worse.
On the plus side, with almost no detent pressure, the knife is super smooth now
