I think my Endura cut me...

JediKnight86

JediKnight86

Joined
Jul 9, 2003
Messages
1,702
...but not the edge, the hole! I was trying to do a s-drop with my Endura, which is hard bc the movement is tight and the FRN has no weight for momentum, and then I look down to see blook on the handle and my thumb. I didn't feel it, don't know how the edge got me, and the cut is crescent-shaped, so it looks like the hole did it....?

Edit: It was the hole! The top part of the hole on the left side (where you're thumb hits if you're right handed) is actually rough and kinda sharp compared to the rest of the hole.... :confused:

Guess I have to exchange it again... :( First a chipped serration, and this one has a rough edge on the same spot in the serration...Are these tan ones lemons?
 
Yes, some of the holes are sharp enough to produce a slight cut. I chamfer most of the holes slightly by using a dowel with fine wet/dry sandpaper wrapped around it. Much more comfortable but not beveled so much that my thumb slips ouit.

David
 
got a sharpmaker?? Just use the corner on a medium or fine rod to smooth it out a bit.
 
I've cut my thumb twice with the hole on the Native III. It's only happened while doing the spydie drop though. I fixed it by filing the edges of the hole down.
 
You must log in or register to reply here.
Back
Top