Infidel pointers or advise

[chopsaki]

so I got an infidel in for sharpening and I was wondering if anyone had sharpened a few of these on a fixed system and can offer any pointers. I did a quick search and all I could find was a couple posters disagreeing if it was a chisel grind or a single bevel...

My question would be any tequnique in removing the burr on the non beveled side. Would you strop it or use a high grit stone like a Arkansas translucent or a choosera stone? Should I use the same angle or a lower one than the bevel side or does it even matter?

 

[chopsaki]

Finished it. Just did 20dps with 25 micro. It’s a puncture weapon not a cutter so I thought a wid t angle would be more stable. Apexed the micro and cut the burr off with edge leading strokes with 1500 diamond.