Is it normal for a new kabar knife to have a flaw on handle?

Status
Not open for further replies.
Joined
Nov 16, 2011
Messages
39
I just have bought a new 5011 and have never used it yet, but I found a flaw on handle. Is it the problem of the Finish of the knife? Or is it normal sympton of very KABAR knife?
12RzVX.jpg
 
xuli0009,

That is not the norm.
You can send it to my attention and I will exchange it.

Address:

KA-BAR Knives
200 Homer Street
Olean, NY
14760

attn: Paul Tsujimoto

Please send a short note explaining the problem.

Hope this helps.

Best Regards,

Paul Tsujimoto
Sr Eng
Prod Dev and Qual
KA-BAR Knives
 
Did you use a magnifying glass to see that? Doesn't look like much of a flaw to me, but hats off to Toooj for taking care of it.
 
omg.... how could that have left the factory?? :rolleyes:



Good on you Toooj, you and Ka-Bar are some really good people
 
Toooj perhaps the factory this defective knife came from should be shut down. Maybe even burned down. I mean, the gall of QC to let a knife with a ninetieth-of-an-inch little tiny ding escape out into the wild.... somebody probably paid over forty bucks for that knife! Why, in my village, that's a year's salary.
 
I've had $500 Busses with worse imperfections. I just sanded the micarta till it looked right.
But some folks buy with safe queens in mind. Kudos to Tooj and Ka-Bar for the replacement.
 
Gee, if you get any more of those "terrible defects":rolleyes:, just send them to me and I'll find them a good home.:D
 
I'm a loss for words, for once. Well, other than 'Kudo's toooj, you handled that like a pro'...wow, just wow!
 
Good thing many new members are bringing their scanning electron microscopes to find these flaws. :D
 
Toooj,
You handled this a lot different than I would have. I guess I'm just not a good appeaser. You're a stand-up guy, though.

EarlFH
 
Okay, folks... show's over. Before the pile-on gets too large, I'm going to shut this one down.
The OP wasn't satisfied with his knife, Tooj is taking care of him, end of story.
 
Status
Not open for further replies.
Back
Top