Is there a certain tool to tighten/loosen Spyderco Mil or PM2?

[csisland]

I don't want to strip the screws but it looks like it uses a hex key. Is this right?

 

[hazy]

Its usually a torx bit for the screws on Spydercos.

 

[Cereal_killer]

Torx, not hex.

Milli = T15 pivot
Not sure about PM2 but I'm guessing T9

 

[Cynic2701]

It also depends on the stepped pivot. It may not be possible to tighten the screws to the tightness that you want.

 

[csisland]

Been using a hex key twice so that was a no no. Didn't strip the screw but I need to pick up a few of those torx bits.

 

[liamstrain]

PM2 is Torx 8 (body) and 10 (pivot), iirc.