JD's devils tail neck dagger

[butcher_block]

just finished up as a side project
its cpm3v 1/8 inch spine flat ground double edged necker
the blade is a hair over 3 inch long and over all its just over 6 inches
the handle is my hand layed "burl" mycarta and the pins are stainless
the blade finish is 600grit hand rubbed

thanks for looking and feedback and comments are welcome

 

[butchesforge]

Wicked little knife-I like it--Butch:thumbup:Especially like your grinds,nice!

 

[westllen]

that is smok'n cool!:thumbup:

 

[samhain73]

That is really cool!

 

[ryan9977]

butch....it looks cool....i like most of your mycarta....i always liked the red and black together.....what's cooler than a dagger too......the only thing i would want different is a slimmer profile for the blade.....that's just me though......if u could slap a jd logo on that i bet u could sell a whole lot of em over there.....ryan

 

[jaislandboy]

great job butch:thumbup:

 

[butcher_block]

thanks guys
it will be raffled off in the next few days on the JD forum (least i think so) i have to see how the sheathing goes