Jigged bone slip joint

C

Craigb

Joined
Nov 21, 2004
Messages
268
This is a new one I finished last week. 3 7/8 closed and 7 inches open. Milled 410 integral bolsters / liners with amber jigged bone and file worked liners. The blade is CPM-154 at 60 RC with a half stop and pivot bushing.

Thanks for looking.

Craig


LC001-1.jpg


LC002.jpg


LC003.jpg


LC005.jpg


LC004.jpg
 
Well, that is a lovely, and no mistake.

I sure wish it was in my pocket right now!
 
I think it's one nice looking Knife, Craig.. Nice blade grind and finish, and the overall profile is very simple and clean.. Well Done.. Do you sell pieces now and then over in the "exchange" area? Best, Rich Slaughter
 
Thanks everyone. Rich I will try to put something in the exchange later. I need to finish a few orders first.
 
You must log in or register to reply here.
Back
Top