KB27D running 2 motors

A

AKShooter907

Joined
Sep 26, 2017
Messages
14
Hello

I’ve spent time searching. Seems like the referenced threads are possibly too old. I get an error when trying to navigate to them

Anyway. KB27D. 2 horse power 3-phase motors and I’m going to run off 220v. Want to run them individually off the single KB27D

I also would prefer running the rotary switch rather than the plugs. Does anybody have a model for the rotary switch? Or point me at a thread I didn’t find? No electrician here. But capable as long as I have a good reference.

Thanks. Plan is to add the disk grind to the sanding table.
 
Here is how to open up an old thread that was disabled by the last server changes:

Attention - How to Find a Sticky Thread that comes up "OOPS! in a link - and how we can fix them together

Many of us are frustrated when a link in the stickys gives us, Oops! We ran into some problems. The thread is still there, the addresses were all modified by the new forum changes a while back. Here is how to find those threads: To find a thread that the link does not open do this: 1) Open...
www.bladeforums.com www.bladeforums.com
 
You must log in or register to reply here.
Back
Top