KD Knives

[KD Knives]

This is my first post on this forum so Hi everyone !
Short info about me and my knives My name is Kamil Dlugosz and I'm from Poland I started making knives in 2010 when I was 17 yo and since 2014 I'm full time knifemaker
I'm using mostly Elmax steel, but sometime also M390, CPMS30V, CPMS35VN as well For handles I prefer G10, Micarta and Carbon fiber, sometimes but rarely atabilized woods.
One of the most important things for me is the quality workmanship and clean designs.
Now I'm working on my first folding knife

I hope you like my works

if I made any language mistakes, please forgive me

Me at work

Best Regards,
Kamil

 

[austexjg]

Welcome - good looking blades your producing.

 

[TRfromMT]

Very nice, and very clean! Thanks for sharing and keep them coming.

 

[Cap’n Smudge]

Very nice, and very clean! Thanks for sharing and keep them coming.

This is basically what I was going to say.

Kamil, thanks for posting! Hope to see more of your work.

 

[watermule]

Always nice to see your work, I remember your work from the British Blades forum that used to be.
Rob

 

[john april]

welcome to the forum ! the knives look excellent and the shop looks very nice.

 

[Mike157]

I agree with the previous comments.... very clean, well finished, well executed designs with nice flow. Great work! Mike

 

[i4Marc]

Nice clean work and practical designs. Welcome.

 

[Planterz]

Wow, it must have taken you forever to decide which knife to use that snakewood on. Amazing figure on that wood.

 

[SharpByCoop]

Legendary Polish attention to detail. Look at these! I foresee a great future.

Become a knifemaker member and post MORE! Thank you.

 

[The Shatz]

Great looking work are you planning on selling here in the makers section?

 

[KD Knives]

Thank you for such a warm welcome !

SharpByCoop thank you ! It's an honour to hear such words from you !

T The Shatz yes, but please give me a while to get used to this forum

Some more photos of my knives
Cayman- one of my favourite's this one was made of Elmax steel and sandblasted Carbon Fiber. Overall length about 262mm and 132mm cutting edge.

Newt- small EDC knife, also really like this project, this little knife was made of Elmax steel with Olive Green textured G10. Overall length about 145mm and 65mm of cutting edge.

Best Regards,
Kamil

 

[mknife]

Hi Kamil, welcome. Your knives have very usable lines and materials ;-)

 

[giedymin]

Hello Kamil.
Fit and finish of these knives is amazing. I had a pleasure to hold a few.
Great work. Your workshop looks sooooo clean)

 

[KD Knives]

Hi

Finished my first folding knife- Arsen Blade made of M390 steel, full titanium handle and ceramic bearings, overall length 211mm, cutting edge 93mm

Best Regards,
Kamil

 

[giedymin]

I like it a lot Kamil.
Beautiful.

 

[Tommy-Chi]

Where can we buy your knives?

 

[R APPLEBY]

You're doing a great job. Looking forward to seeing more of your work.

 

[KD Knives]

R APPLEBY Thanks !

T Tommy-Chi I just started collaboration with Fort Henry Knives, so some of my knives will be available there of course you can order directly from me as well.

 

[vox801]

The Arsen is a great looking knife. Well done. I see one in my future.