Ken Coats EO Plucker

kc custom

kc custom

Joined
Apr 20, 2005
Messages
2,351
This is another one I made for a forum member, Hollow ground blade ats-34 cryo treatment. Liners, Bolsters, integral. My jigged and dyed bone. I wanted to make the pen a bit longer on this one and dropped it lower so the top of it stays below the EO notch. Take a look
Ken.

100_0448_edited-1.jpg
[/IMG]
 
Ken,that's a real good looking knife :thumbup:
Great blades on that one,useful.Gorgeous bone.The fit looks top shelf :thumbup:
Thanks for showing it,
-Vince
 
Are you kidding me (insert pause) :

That is one hell of a pattern and one hell of a knife. I would EDC it as my primary knife in a heart beat. Integral bolsters and liners, Awsome!
 
That's a fine looking knife! The owner is gonna love that!
 
Great looking knife Ken. I love a sheepfoot blade, and I can think of a lot of uses for that pointy clipped pen! Nice bone!
 
kc custom said:
The knife is right at 3 7/16" long closed
Ken.
Click to expand...
Sweet! Nice pattern, very nicely done. I like the bone and the shield too. Something about the proportions made me think it was shorter than that - I would have guessed close to 3" long.
 
Last edited:
Bone looks amazing. I actually like the size of the pen blade...but for symmetry purposes, maybe you can groove out the liner/bone on the other side so you can just pull it out with thumb/pointer finger. That would look sweet.
 
You must log in or register to reply here.
Back
Top