Kershaw/ Benchmade screws

[upperclasstwit42]

I was wondering if anyone knew what kind of tool was used for the screws on either the kershaw leek or the benchmade grip 550. I'm trying to move the clips and i can't find anything small enough.
thanks

 

[wwells20]

my bm555 uses torks but very small ones. you can get the service kit from bm but what i did was go to home-depot and where they have the screwdrivers, look for a small torks driver with four dubble-ended bits. mine works fine and on other knives too!

 

[G1ZM0]

Torx bits is probably what you need.

I found a set at Sears that had bits small enough to fit most of the knives I own.

Check there and Home Depot and you should be able to find what you need.

I'd take your knive with you so you can check.

 

[JD Mandrell]

I was wondering if anyone knew what kind of tool was used for the screws on either the kershaw leek or the benchmade grip 550. I'm trying to move the clips and i can't find anything small enough.
thanks

The small screws on the grip are a T6 torx for the clip, the pivot is a T10.