Kershaw Cryo

[bonzodog]

Arrived this morning ,what a lot of knife for a small outlay.Out of interest can the A O be removed .Hope I don’t start on the Zt road.Like the look of the 0550..

 

[KnottyEagle]

The AO can be removed, but the blade would be flopping all over the place because the Cryo doesn't have a detent.

 

[bonzodog]

The AO can be removed, but the blade would be flopping all over the place because the Cryo doesn't have a detent.

Thanks for that,I will have to be careful where this goes.

 

[mountainbound]

Arrived this morning ,what a lot of knife for a small outlay.Out of interest can the A O be removed .Hope I don’t start on the Zt road.

but its a great road i was looking at the cryo too, nice looking blade.

 

[chrischoi]

You could torque down the pivot screw a little for some extra retention. It could slowly release, but it will require a little extra force. I don't mean lock it down in there, but if you tighten it just a little bit it can hold.

There was also a video on YouTube of someone putting in his own detent. Looked pretty easy and was done with a Dremel.