Kershaw Skyline help

[Phil7153]

I made some kershaw skyline scales and im tring to install them, but how do you take those little wellnuts that the two back screws, screw into. I can not for the life of me get them out of the existing g10 handles. Any help would be greatly appreciated.

 

[Phil7153]

No one has any advice??

 

[Razorsharp-Travis]

I just took mine apart, want to make scales too, just push them out with a screwdriver from the inside of the scale

 

[Phil7153]

I just took mine apart, want to make scales too, just push them out with a screwdriver from the inside of the scale

I tried that, and they wouldnt budge. Its becoming quite aggravating.

Update: I took the knife completely apart, took the scale with the little wellnuts that are stuck in, i screwed the screws in half way from the inside of the scale and pushed as hard as i could on the table and they poped out. So for anyone struggling like i was, i found the solution.

 

[Skimo]

So were they press fit or did Kershaw use an adhesive?

 

[Phil7153]

So were they press fit or did Kershaw use an adhesive?

they were press fitted with an adhesive. Suckers were in there tight.

 

[Razorsharp-Travis]

pics when your done

 

[Phil7153]

pics when your done

for sure, and to make the anticipation worse, there is glow in the dark pigments involved.

 

[Razorsharp-Travis]

ooooh boy

 

[vaisforloverss]

I tried that, and they wouldnt budge. Its becoming quite aggravating.

Update: I took the knife completely apart, took the scale with the little wellnuts that are stuck in, i screwed the screws in half way from the inside of the scale and pushed as hard as i could on the table and they poped out. So for anyone struggling like i was, i found the solution.

Thank you so much for posting this and your solution! I was having a bear of a time getting them out. Once again, Thank you. Have you posted pictures yet?