Keyholes Heading to Atlanta

[KHall]

Hi Everyone,

Here are two keyhole and a few other knives headed to the Blade Show. I will be at table Q16 hope you can drop by and check them out.

Regards,
Ken


Keyhole Hunter
Steel – W2
Knife dimensions:
Overall length – 10 5/8 inches
Blade length – 5 5/8 inches
Blade width – 1 3/8 inches
Handle – Desert Ironwood
Guard – Bronze

Keyhole Fighter
Steel – W2
Knife dimensions:
Overall length – 12 3/8 inches
Blade length – 7 3/8 inches
Blade width – 1.75 inches
Handle – Stabilized Curly Walnut
Guard – 410 Stainless Steel

Damacus Fighter

Steel – 1095, 15N20
Knife dimensions:
Overall length – 11 inches
Blade length – 5 7/8 inches
Blade width – 1 3/8 inches
Blade thickness – 1/8 inches
Handle – Stabilized Madrone Burl
Guard – Stainless Steel
Pin – Nickel sliver

Chef's Knife
Steel – 1095
Knife dimensions:
Overall length – 14 1/4 inches
Blade length – 9 inches
Blade width – 1 15/16 inches
Blade thickness – ¼ inches
Handle – Stabilized Leopardwood
Bolster – Bronze
Pin – Stainless Steel

 

[Big Rick]

Ken, all very nice knives, having a pair of your keyholes I know that the fit and finish will be excellent. I do like the Damascus fighter though!

 

[KHall]

Thanks Rick

 

[Burl Source]

They all look great!
Thank You for sharing the photos.

 

[Dawkind]

Fine job and congrats on the ABS JS knife...another piece well done.

 

[EScott]

Nice work. See you in a few days.

 

[KHall]

Thanks, Mark, Dawkind and Scott.

Ken

 

[Steve Randall]

Great line up Ken. I like your damascus on the fighter a lot.

see you in Atlanta

Steve

 

[KHall]

Thanks Steve, see you in a few days.

Ken