Erin Burke
KnifeMaker...ish
- Joined
- May 19, 2003
- Messages
- 1,330
This knife has been sitting on my bench since last September. I am filled with relief that it is finally complete. This is my first attempt at filework, and only my second knife using frame-handle construction.
Some Stats:
Length: 14-1/8"
Blade: 8-3/8" (Tip to Choil)
Steel: Differentially heat-treated 1095 (from Kelly Cupples) Flat-Ground
Handle: This was an unlabeled set of scales from my stash (only marked "stabilized") - I believe it is Madrone burl, but don't quote me.
Frame is 1095.
Guard/Ferrule: 416ss w/ 1095 spacer
The handle color appears quite red in the second and third photos... while there is a red tint to the scales, the coloring is actually more of a brown like in the last two photos.
There are a couple small gaps in the blade/guard/frame fit-up that became apparent after the clamps were removed... but as a new maker, I am pleased overall with how this one turned out.
What do you think?
Erin
Some Stats:
Length: 14-1/8"
Blade: 8-3/8" (Tip to Choil)
Steel: Differentially heat-treated 1095 (from Kelly Cupples) Flat-Ground
Handle: This was an unlabeled set of scales from my stash (only marked "stabilized") - I believe it is Madrone burl, but don't quote me.
Frame is 1095.Guard/Ferrule: 416ss w/ 1095 spacer
The handle color appears quite red in the second and third photos... while there is a red tint to the scales, the coloring is actually more of a brown like in the last two photos.
There are a couple small gaps in the blade/guard/frame fit-up that became apparent after the clamps were removed... but as a new maker, I am pleased overall with how this one turned out.
What do you think?
Erin
Last edited:
