Hi there, dear sirs.
This is my debut on this well-known and worldwide honored forum so a couple of words about me.
My name is Andrei Starostin and I'm already trying to do knives for more than 5 years.
Let me show my latest work, Kookrie Mk.3, with light changes in geometry of blade and personal construction of sheath.
The blade was made with flat grind of Crucible D2 steel with selective hardening of 55-57HRC, well viewed on the photos.
Oal is 401mm, blade length is 280mm with cutting edge of 190mm, blade wideness is 55mm, blade thickness - 8,5mm (tapered tang to 5mm till the end of the handle).
The handle material is brasilian teak scales screwed via bronze washers by mean of stainless screws.
Sorry for my command in english and for some silly stitch mistakes on the reverse side of the sheath.
This is my debut on this well-known and worldwide honored forum so a couple of words about me.
My name is Andrei Starostin and I'm already trying to do knives for more than 5 years.
Let me show my latest work, Kookrie Mk.3, with light changes in geometry of blade and personal construction of sheath.
The blade was made with flat grind of Crucible D2 steel with selective hardening of 55-57HRC, well viewed on the photos.
Oal is 401mm, blade length is 280mm with cutting edge of 190mm, blade wideness is 55mm, blade thickness - 8,5mm (tapered tang to 5mm till the end of the handle).
The handle material is brasilian teak scales screwed via bronze washers by mean of stainless screws.
Sorry for my command in english and for some silly stitch mistakes on the reverse side of the sheath.
Last edited:
