Lansky Diamond system for reprofiling?

KarlMaldensNose

KarlMaldensNose

Joined
Feb 3, 2009
Messages
1,342
Sorry if this is redundant, but I did try a search first and the results didn't get me to where I want to be, so...

Has anyone had success reprofiling harder stuff (e.g. s30v, D2, ZDP-189, etc.) with a Lansky Diamond Sharpening System, either standard or deluxe?

I need something for reprofiling (mostly s30v) and I'm not completely sold on diamond rods for my Sharpmaker (not versatile enough) and diamond benchstones are not a viable option for what's available to me here in Canada (only the older perforated DMT stones can be found).

Also, the settings on the Lansky are 17, 20, 25 and 30 degrees. Are those angles inclusive or per side?

I would sincerely appreciate anyone's input here. Thanks, and have a great day.
 
I have used the Lansky diamond stones to reprofile, ZDP189, S30V, VG10.
THe ZDP takes a while, but it can be done.
the Lansky settings are the half angle, not the inclusive angle. That is a problem if you want to reprofile to 10 deg
 
I use the Smiths diamond system which is very similar to Lansky. I actually like it much better. It works great for reprofiling. I have done ZDP189, S110V, S90V, S60V, S30V, CPM D2, etc. with little problems. It will take a little time. I usually use the coarse to get the initial angle and then refine from there. I believe that the angles are inclusive. I have three different types of these systems and even though the angles are marked the same, they are all different. :)
 
Okay, so if Lansky angles are per side then that means the smallest inclusive angle it can put on a blade is 34 degrees (from the 17 setting)!?! I don't think I'd be happy with that. I want stupid sharp edges at angles that will roll in the face of a stiff breeze. The search continues...
 
You might want to avoid the Lansky diamond hones, they don't last, probably not built for long term or hard use.

Consider the DMT Magnaligner instead. Excellent piece of sharpening equipment that doesn't cost a fortune, is adjustable, portable. The Deluxe version comes with two Diafolds and 4 very useful grits. The guide can also be adjusted for use on a standard benchstone adding to it's flexibility and usefulness. I learned alot about freehanding using one.

http://dmtsharp.com/general/new.htm#dmgef

Give it a look see.
 
Native,

I'm constrained somewhat by my location. Most DMT products (save for their older 'dotted' diamond surfaces) are unavailable to me in Canada. No aligners, no diasharps, no fun. I guess I could order across the border but I HATE:grumpy: all the extra fees and rates that go along with it. I will break down and do it when I want something bad enough, like my Ritter Grip and incoming PT CC, but sharpening equipment just doesn't qualify. Thanks for the recommendation, though:).
 
KarlMaldensNose said:
Okay, so if Lansky angles are per side then that means the smallest inclusive angle it can put on a blade is 34 degrees (from the 17 setting)!?! I don't think I'd be happy with that. I want stupid sharp edges at angles that will roll in the face of a stiff breeze. The search continues...
Click to expand...

I have not been able to use the 17 degree setting on my lansky for my slipjoints because the stones hit the clamp. 20 degree for a 40 inclusive is the best I can do. I still enjoy the lansky. It is important to keep the stones clean. I use the bar keepers friend, it works great at pulling off the caked up metal and dulling the stones.
 
You must log in or register to reply here.
Back
Top