Large Inkosi question

[Sullivan27]

Does the stop pin screw need loctite on a large inkosi? I’ve tightened it down well and it keeps coming loose. Something I’m doing wrong?
Thanks

 

[Steely_Gunz]

I put loctite on pretty much all of the load bearing structure of my Inkosi. I havent heard of the stop pin coming loose, but it I would hit it with some loctite and see if that helps. If not, a trip to CRK might be needed.

 

[SuzukiGS750EZ]

My inkosi came with loctite on the threads and I’ve since cleaned it off. You don’t need a ton but yes, you can apply it. A little goes a long way. Clean and ease your knife well, apply a line of loctite down one side of the pivot screw and put it together. Make sure the tension is how you like it and leave it overnight.

Edit: I failed to retain the fact that you said stop pin and my mind went to pivot. When you tighten your stop pin does the stop pin spin or actually tighten?

 

[Ajack60]

Check to make sure there’s no obstruction in the thread well preventing it from seating all the way. It should bind on the titanium to help it from backing out.

 

[BTTLBRN]

I’ve had an Inkosi that the stop pin would back out on, I used the CRK supplied loctite and it never happened again.