Link problem / Handle screws

coop1957

coop1957

Joined
Oct 22, 2002
Messages
2,624
Recently got a Kershaw Link and I like it well enough. I understand that it can be deassisted. One problem - I can't seem to back out the T6 screws on the handle. The female side spins freely and the screw will not back out. This happens on all 3 of the handle screws. I've tried to press an eraser against the female side to keep it stationary but this doesn't work.
Any suggestions?
 
Try breaking the Loctite with heat. Touch a soldering iron to the screws and then quickly try loosening them while they're hot. Just don't heat them to the point of damaging the scales. It worked on my wife's ZT0350. Good luck.
 
You must log in or register to reply here.
Back
Top