- Joined
- Apr 18, 2013
- Messages
- 8
Hi. I'm a new poster here, (even though I've been a member since 2012). I apologize if I'm in the wrong place, I tried to find a new posters guide or whathaveyou, but this website is pretty difficult to navigate on mobile. Please bare with me.
http://imgur.com/a/NhzvS85
Ordered some Z wear (13.5 in x 1.8 x 308in) and a sheet of 6-4 Ti (1.58 x11.5 x 2 in)
I linked a refined design of something I did in D2 and horn, and was hoping to get your input.
It will be a an 11 inch overall full tang Z wear chopper. 4.75 in flat grind drop point blade, with a 3mm stock tapered down from a 4 mm tang. I'll be sending it to allied heat treating for cryo as per ZAPP's recommendations, to hopefully achieve 60 hrc, temper and black oxide.
I'll be using coloured kydex spacers under Ti scales, secured by Ti M4 hex screws.
Any thoughts on anything you'd improve/change or omit would be greatly appreciated.
Thank you.
http://imgur.com/a/NhzvS85
Ordered some Z wear (13.5 in x 1.8 x 308in) and a sheet of 6-4 Ti (1.58 x11.5 x 2 in)
I linked a refined design of something I did in D2 and horn, and was hoping to get your input.
It will be a an 11 inch overall full tang Z wear chopper. 4.75 in flat grind drop point blade, with a 3mm stock tapered down from a 4 mm tang. I'll be sending it to allied heat treating for cryo as per ZAPP's recommendations, to hopefully achieve 60 hrc, temper and black oxide.
I'll be using coloured kydex spacers under Ti scales, secured by Ti M4 hex screws.
Any thoughts on anything you'd improve/change or omit would be greatly appreciated.
Thank you.