Looking for some Bubble Jig users to test out new length clamps.

[Fred.Rowe]

We have been making the Bubble Jig for 6 years and have shipped over 2,000 of them. I've been tinkering with some new grinding clamps and I want to get some feedback on them.

The standard clamp is 6 inches long, the new ones I want feed back on are 5 inches and 4 inches long; with the shorter one having carbide inserts installed on one side.

If you are interested in testing these out sign up below, I'll take the first ten makers. The only two requirements is you must have a Bubble Jig so you have a basis for comparison and an e-mail is needed.
You can keep the clamps for 5 days and then ship to the next person on the list.

If there is an interest in this lets get it rolling.

Regards, Fred

Picture shows the 4 inch 5 inch and the standard 6 inch clamp.

 

[Living The Dream]

In please. The standard clamp barely fits inside two notches on the left side of our platen.

 

[kuraki]

I'm using your jig, but I don't use the clamp at all. Just the magnet and level.

 

[Greenberg Woods]

I'm in. I'll be back in the shop in about 5 days, but ii have a lot of knives to grind.

 

[Fochops]

I'm in, I have the same problem with the original clamp. Can't use it on the left side of my platen.

 

[HSC ///]

never mind
cancel