Low-rider clip for 0350?

[riot]

I've had my 0350 for a little over a week now. I love it so far, but it's a little bigger than the Delica I normally EDC. I would like to get it down into my pocket a bit more. Is there an aftermarket low-rider clip for the 0350? I searched around and couldn't find anything. Thanks!

 

[sticktodrum]

Keeping in mind that the clip for the 0350 is the same as the 0300, a bunch of other ZTs, the Skyline, and a bunch of other Kershaws, the best I've ever found on that style clip is this write up tutorial on a relatively easy mod. If you email or call Kershaw, you should be able to get an extra clip or two to try this out.

http://www.bladeforums.com/forums/showthread.php/845727-Kershaw-Skyline-pocket-clip-mod

 

[riot]

That's a great idea, but I'm not handy enough with tools to pull it off. I was hoping to find one I could bolt right on.

 

[sticktodrum]

Well, I'm going to try my hand at that this week, so if it turns out well I'll try to make one for you.

 

[chester22]

I think Gooey on the forums makes a pretty cool one for his ZT0200.....(same clip)

 

[viper89]

I think STR here on the forums make a pretty good Ti deep carry clip.

 

[chester22]

One Gooeytek made..

don't know if he'd sell them but looks pretty awesome to me

 

[sticktodrum]

I asked STR about a clip for the Skyline, which would obviously fit many other ZTs/Kershaws, but he said the spacing of the holes were too close for him to make a clip that he felt was strong enough with a loop around.

 

[gooeytek]

It's not at all that narrow where the bend is, I have other Ti clips that are even slimmer than the ZT versions and they're still very secure. The trick is to put the screws in the clip before you fit and tighten them onto the knife, and this is assuming that the torx driver you have is much thinner than the diameter of the screw head. A torx bit won't work. I'm always trying out new designs though, the ZT lowrider clip is somewhat elusive.