Low Rider Clip for the Gunhammer

I've only seen a custom of this model by Darrel Ralph and pretty sure it has a low rider on it that he makes. Is there another? If so I need pics. Thanks
STR
 
I have the M390 version and its such a high rider it would make as much sense to clip it to the outside of the pocket.
Most of his gunhammers I have seen have this http://i42.tinypic.com/2zgf57p.jpg http://images.knifecenter.com/knifecenter/htm-knives/images/HTMMFDRGHRDHAOa.jpg (different views)

The low rider seems to be only on the customs which sucks. Its like having a penguin in my pocket.
http://www.knifecenter.com/item/HTM...wie-Assisted-3-12-inch-Satin-M390-Plain-Blade
mine is a black on black but it just seems too much. feel the masterclipsmith would be able to assist me here.

What do you say doc? Can you save my pocket from that awkwardness?
 
The inlay or nested clip designs are particularly problematic to do with a low rider. It depends on some with the depth but even a little is a lot in a folder and the clip has to at times have four bent spots to make it work as opposed to the normal three. You are also looking at a specialty one off clip as I call them and those are more than my normal routine run of the mill clips that come in all the time. Those are the ones that are my min. shop fee of $30 but the specialty type clips are $45 and even that isn't enough at times to make up for the time diff between doing it and doing two or three of the normal clips I get asked to do. I tell you this just so you can see from my stand point the clips like this kind of fill up a schedule sometimes requiring two tries to get one I like well enough to send home. Anyway, if it is worth the $45 to you on that knife and the spacing of the two screws is about 1/4" on center or better by a tad we should be able to make something to work but I'm a bit concerned about the cock in the clip because the low rider has to fold over and do a 180 right above those two screws and access to the screw heads to remove and install the two must be present once the fold over stem is weaving in between there. It looks tight to me and that is why I'd like to know the spacing on center of the two holes. Thanks
 
ya, damn. I will contact Darrel and ask him if he will sell a low rider clip for it. Thanks man, if you say its hard then it must be hard. take care clip doctor

i can send the knife into you later with 50ish dollars if he can't do anything. sound like a plan? I just need a low rider clip because it is like an inch of black aluminum handle sticking out and is too obvious. I need to send it in for some maintenance but m390 gunhammer at 62hrc can be a great edc after some mods (carbon fiber scales after i get the clip worked out probably)
 
Last edited:
You must log in or register to reply here.
Back
Top