Machete in 3v?

[pinkfloyd101]

How many of you would like to see a golok type machete in the 3v steel? Would this steel work well with such a large knife? Your thoughts?

 

[jakeyjake4528]

I'd like it, but itd just be overkill.

 

[cotdt]

it would be expensive

 

[DennisStrickland]

agree with cotdt as to expensive. the strong point of machetes is the low cost.

 

[Big Mike]

Bark River's new Bravo-3 should fit the bill.



Click to enlarge


With a 12" blade of CPM-3V it will be longer then their Golok.


But, considering the size of the piece of 3V required, it won't be cheap.




Big Mike

 

[TOMMY00729]

Well yes it would be high $ , but would like to see one & the rewiews!

 

[bearcut]

Bark River's new Bravo-3 should fit the bill.



Click to enlarge


With a 12" blade of CPM-3V it will be longer then their Golok.


But, considering the size of the piece of 3V required, it won't be cheap.




Big Mike

Where do you find infomation on this knife?
About the only thing I've found out about it is that is is still a couple months off.

Holy crap, 12 inch blade?!
I hope BKRT did the smart thing and made it thin, (that's one benefit of supersteels I thought) otherwise it is going to be quite the boat anchor.

 

[rctk1]

i know Bill Siegle made one in 3v a while back. it sure didnt stay on the "for sale" section long.

 

[tsdevanna]

If they will make it and have someone do the testing and reporting I'll donate the steel.
scott devanna

 

[razorburn]

i know Bill Siegle made one in 3v a while back. it sure didnt stay on the "for sale" section long.

I remember reading about his machete, it was $300.