MagFire Pro or WSI p-60C Fire starters

Z

ZZZ

Joined
Oct 22, 2004
Messages
14
I have narrowed down at two Fire Starters

A) MagFire Pro

B) WSI P-60C

Which is the Better of the two?[/COLOR]

ZZZ
 
They're cheap. Buy both and let us know what you think.

My preference is a round mag rod with a groove machined in it. The sparking rod is epoxied into the groove then entire setup is epoxied into a piece of pitch wood. A short section of hacksaw blade is then attached by a cord. Done.
 
Holy sh*t the WSI P-60C is way to expensive for what you get, in my opinion. A Doan mag tool is less then $10 and a ceramic sharpening rod is only $1 at Smokie Mountain Knife Works.
 
Can't compare the two - I don't have a P-60C, but I do have two Magfires & they work very well. :thumbup:
 
I finally figured out why they sell a sharpening stick attached to a firestarter. After you've finished using your knife to shave off enough magnesium to start a fire your knife is so dull that you'll need to use the sharpener to get the knife back into usable form again.

But seriously folks ....

Save your money and get the MagFire Pro TODAY, before the sale ends!!!
 
You must log in or register to reply here.
Back
Top