Makers Mark Hot Stamp Size/Source

[Branson1369]

New maker finally ready to hot stamp my forged blades with my name “Branson” and looking for guidance on height/width of letters. Also curious were folks are getting their stamps made

thanks in advance for any advise

Branson

 

[HSC ///]

Buckeye engraving

 

[Stacy E. Apelt - Bladesmith]

Henry A. Evers.

About .75"/20mm long. Height is about .125"/3mm. Obviously, these will have to be adjusted to fit the number of letters you want on the stamp. H.A.Evers will work up an image for approval.

I have almost stopped hot stamping knives and either engrave the makers mark or use an etcher.

 

[Branson1369]

Henry A. Evers.

About .75"/20mm long. Height is about .125"/3mm. Obviously, these will have to be adjusted to fit the number of letters you want on the stamp. H.A.Evers will work up an image for approval.

I have almost stopped hot stamping knives and either engrave the makers mark or use an etcher.

Exactly what I was looking for! I could not find any length height info on line