Master Williams needs V-belt Pulleys

[Mark Williams]

Someone have a line on somewhere that has a good selection. Master Williams needs a v-belt pulley for a 1 1/8 shaft.

 

[Burchtree]

Ace Hardware always has a good selection -- (at least here in da Ozarks.)

 

[Arthur Washburn]

The local gas station here caries them and also the auto parts store.

 

[insanity]

McMaster-Carr at mcmaster.com will prolly have any you would want.

 

[Dan Gray]

McMaster-Carr at mcmaster.com will prolly have any you would want.

Odda do you need the magic one or the plain one just 2500.00 for the one that will out run them all

 

[Bastid]

Dan,

I think The Master is looking for the mystic ones. Last time I looked they were even more expensive than that.

 

[Mark Williams]

No just a plain will work for Master Williams. Master Williams misses real hardware store. Master Williams is sick of the city.

"GRRREEEEEEN acres is the place for me. Laaaaannnnd Spuuredin' out so far and wide... The Master kills the Master

 

[Tarl_Cabot]

!Attention!

This is Master Tarl...! :grumpy:

Master Williams...Proceed to the nearest Granger Supply for all things holy and mystical regarding pulleys, sheves and mystery gears for thine shop!

Here's a link to the "Red Brick Road":

http://www.grainger.com/Grainger/wwg/start.shtml

 

[Mark Williams]

Master Tarl is providing path to circle of enlightenment.

 

[Tarl_Cabot]

Lmao.... :d

 

[Stacy E. Apelt - Bladesmith]

Methinks that Master Williams has been breathing the fumes from his quench tank too much lately!
His wife often hears him out in the shop,late at night,crooning,"My precious,my precious."
BTW,if you have no fear,ask mark for the formula to his quench mix.

 

[Doc Hollywood]

Master Williams needs to look into casting aluminum in a small charcoal powered furnace, and casting the Masters own pulleys in sand. The Master woudl save mucho dough by casting them in scrap aluminum that I am sure even the master has laying around in his junk pile.

If the Master woudl like more info the master can contact me and I can provide the master with a direction to look with relatively simple instructions on how to make the master for his pulleys as well.

Doc

 

[R APPLEBY]

Bearings, gears and drives will have or can get anything you can imagine and the prices are easily afordable.

 

[T Blade]

Pulley's,,,,hhhmmm,,,Master Williams may peruse through http://www.surpluscenter.com/sort.asp?UID=2005013104385338&catname=&byKeyword=yes&search=pulley this website to find the "mystic" or the "plain" type of pulley to meet the Master's requirements.
Prices here may or may not be substantially better than other houses of pulley.

Larry T

Member of NECKA & NCCA

 

[Mark Williams]

Past Master Williams thanks you all.

Hopefully my motors will be here soon. Cant wait to get all this stuff fired up.