Mini Head / Round Knife - Looking for Design Feedback

[J. Keeton]

Hey guys, so I built this little head knife since it was the only size stock I had in my shop. What do yall think?

Are there some tweaks that could make this design any better with the limited 1.5'' wide stock?

PDF Drawing - https://www.dropbox.com/s/qcawoww3cqqyi29/RBO-Mini_Head_Knife.pdf?dl=0

Full Build Video:

 

[leatherman]

Now that is a nifty little knife! THanks for showing it!

 

[Horsewright]

Did ya think on sharpenin all the way up to where the jimping is? Flip it over and that arc would be great for longish straight cuts.

 

[J. Keeton]

Did ya think on sharpenin all the way up to where the jimping is? Flip it over and that arc would be great for longish straight cuts.

That's a good idea! I should of thought of that... I stopped the edge right around the start of the jimping.

 

[Branson1369]

That's a good idea! I should of thought of that... I stopped the edge right around the start of the jimping.

Another tool added to my to do list

thanks

buddy

 

[Horsewright]

That's a good idea! I should of thought of that... I stopped the edge right around the start of the jimping.

Yeah no jimping on the next one and sharpen all the way to where the jimping is.