- Joined
- Jul 5, 2006
- Messages
- 197
I was reading through some old posts and discovered that the one and only Ethan Becker used to post on this board,at least until 2004. Please come back Mr. B.!
What's the best way to sharpen a BK2? The angle geometry of the factory grind is almost a right angle! It seems that a good bit of material needs to be ground off. I thought a convex profile might be of benefit but is sure is hard to sharpen a blade with that profile.
What's the best way to sharpen a BK2? The angle geometry of the factory grind is almost a right angle! It seems that a good bit of material needs to be ground off. I thought a convex profile might be of benefit but is sure is hard to sharpen a blade with that profile.