Modding Buck Strider and other Bucks

[robotech]

I just finished two Buck Striders and a Buck 112 custom.
Here is a Buck 112 that the only thing stock is the blade.
Orange G-10 (coarse) with a white G-10 liner. Custom cut SS liners, new designer pivot and new pins. 2-56 socket head T-8 screws. Got this one down to 3.1oz!

 

[apintandafight]

That looks great! You did good work.

 

[robotech]

Here is a Buck Strider 889.
I polished the black blade and clip. Won't do THAT again! Too work intensive. But, it did come out nice.
Put on a set of Orange/Black/Orange G-10.
Did my pivot bushing mod which includes new stand offs (shorter). This gives a much earlier lock up, and actually centers the blade in the frame.
Used Socket Head 4-40 T-8 screws.
Repositioned the clip for a lower ride.

 

[robotech]

That looks great! You did good work.

Thank you!
I have one more to post.

 

[robotech]

A Buck 882 Tarani.
This one was new, but no box.
I used some Blue/Yellow/Toxic Green G-10 for scales.
Then used some custom stand offs that are shorter to allow my pivot bushing mod.
Used 2-56 Socket Head T-8 screws, and repositioned the clip for a lower ride.

I have two Buck 110's to do, one more Tarani. Then I am going to do a wild custom Tarani for my safe.
So more to come.