Modular Knife System...Mission dependant

B

Black Creek Limited

Joined
Jan 14, 2015
Messages
41
As of now I am calling this the M.K.S. for short, been working on this one for a long time now and I would really appreciate your input before I start running the proto's. The handle starts as .750 6061-T6 with Military Spec. Hard Coat Anodize MIL-A-8625 ( appx. 65 HRC ) Average O.A.L. on the ones you see is about 9'' and the blades are around 3.50- 3.75 The blade material is still undecided, thickness between .156 and .187. The blades you see are the ones I like the best so far but I have many more drawn up, Serrated, Saws, Long blades etc. I also have these models drawn a folders but I am no where close to the level of expertise needed to execute these in the folder designs.
 
Last edited:
The handle will probably have knurling, traction grooves and milled flats on the sides, maybe even some o-rings that set in the grooves and are raised just a bit, a removable end cap, different material for the end cap- thinking heat treated 440c and a small storage area inside the handle. Of course it will not have the strength of a full tang fixed blade but it will be stronger than most frame/liner lock folders which hold up to some serious stresses. I am thinking of offering it as a set - one handle and two blades of choice and additional handles and blades sold separately. Without further ado I introduce to you The M.K.S.
M.K.S..jpg
 
You must log in or register to reply here.
Back
Top