My latest, another try with the fileworked logo

[Matt Shade]

Things have been kinda slow so I thought I throw these out there. If nobody's postin I have to do homework or something and we can't have that

Its 440C, 3.5" blade 7.5" OAL, black linen micarta scales, brass pins and lanyard hole.

I guess I should get an actual size picture of the filework. Its only 1/8" stock and the logo is a little under 1.5" long. I had the lettering a lot thinner when I carved it in but got a little out of control grinding the scales flush

What do you think? Thanks for lookin.

 

[jeyr]

Nice idea i like that don't have to worry about wearing off the logo.

 

[Jose Reyes]

Matt,

It looks good, keep at it!

-Jose

 

[tknife]

I like your logo, very cool!

 

[Matt Shade]

Thanks everybody

And yep, you'd have to have some pretty rough hands to wear off the logo

 

[Keith Montgomery]

Much better, Matt. I think the knife looks just fine.

 

[Matt Shade]

Thanks Keith
Can't remember if it was you that suggested that I hollow out the A and the D or not, but it was easier than I thought. Required a large amount of swearing, buts its something I will do from now on