- Joined
- Jul 29, 2015
- Messages
- 92
Turned out to be an amazing stripper!
It was my first time trying this, so I wasnt sure how it would go but Im really happy with the end result. I was surprised how nice the INFI came out once finished.
A bit about the process: I put a coating of Citristrip on for about an hour, then used a plastic scraper to clean off the coating. There was WAY more decarb then I expected under the Tanker Gray the entire blade was black after getting the outer coating off. It took a lot of time and elbow-grease to get down to the INFI. Started with 400-grit wet sandpaper, then went to 800-grit and finally a scotch pad. But the effort paid off.
This is the TG-M I was hoping for! Very pleased
Before, in Tanker Gray
During
After
It was my first time trying this, so I wasnt sure how it would go but Im really happy with the end result. I was surprised how nice the INFI came out once finished.
A bit about the process: I put a coating of Citristrip on for about an hour, then used a plastic scraper to clean off the coating. There was WAY more decarb then I expected under the Tanker Gray the entire blade was black after getting the outer coating off. It took a lot of time and elbow-grease to get down to the INFI. Started with 400-grit wet sandpaper, then went to 800-grit and finally a scotch pad. But the effort paid off.
This is the TG-M I was hoping for! Very pleased
Before, in Tanker Gray
During
After
:thumbup:
