Need help ASAP!!!!!!!

[Blades2442]

Again not sure where this the Longs, all I know is that I need help immediately, I was stupid enough to take apart my Kershaw launch, and now I can't get it to open when I add the pit screw, what should I do, please help anything you know

 

[Colorodo]

Try here http://www.bladeforums.com/forums/forumdisplay.php/688-Automatic-Knife-Switchblades

 

[juzam182]

Not sure but I might have found a video of the take down, see below.

http://videoyum.xyz/video/y650c529ca0/how-to-take-apart-a-kershaw-knife

 

[benchwarmer380]

The guy in the following video disassembles his Launch and puts it back together. I think it's in Russian, but his visual steps seem well done enough to follow along.

[video=youtube;641jzWuS-x8]https://www.youtube.com/watch?v=641jzWuS-x8[/video]

 

[Blades2442]

Thank you very much guys, I think I solved the issue, when I took The pivot screw down, all the dried up thread lock gunked up the pivoting, so I took the blade and pivot screw in everything completely apart and wiped all the gunk off and put it back together, then I put it to where it needs to be, as in tightness for the pivot screw and then I am going to add a little bit of Loctite, and that should fix it, thanks

 

[benchwarmer380]

Awesome!

You forgot to tell us one bit of pertinent info though. Which Launch?!

 

[Blades2442]

Oh yeah that would be useful, thanks it is the launch 2 and WARNING the back scale screws strip very easily, I have to get a new set sent out to me because of this, they were on so tight!