New handle on SVORD Peasant

M

Msturm

Joined
Nov 5, 2016
Messages
33
Went on my honeymoon to New Zealand. Picked up 4 of these for pretty cheap. Going to give them as gifts. I have a habit of making new handles for knives with plastic on them and this was no different.

I was at my buddy's house giving him his knife and I looked at some Keawe wood on his wood pile and asked If I could split a section off for a new handle. Here is the end result.

Before and after
eL2NTEN.png


On the same split of wood I made the handle from.
X2z4qMu.png


Open on the same split of wood I made the handle from.

voyNkvh.png


Thanks for looking
 
Congrats on both counts! That wood looks beautiful, you did a nice job on that Svord :thumbsup:
 
Nice work! I was about to ask where you found those pivot screws, and then noticed that they came on the knife... congratulations on the wedding too:thumbsup:
 
You must log in or register to reply here.
Back
Top