New neck knife

m. wohlwend

m. wohlwend

BANNED
Joined
Apr 21, 2007
Messages
2,681
I designed a new neck knife this weekend, I will try to get photos up after it's ground. It is bigger than the tin knife, but smaller than the PSK. Handle is long enough to get three fingers on and should hold good in a kydex sheath so it can be a true neck knife. Grind will be scandi. Stay tuned...
 
I got up early, and went to my first day of classes. I had been on the waiting list, but people didn't show up, so I scored all 3 classes I needed. I then rode my bike, and pushed it real hard (25mph) for a few miles. That put my blood sugar down to 66! :eek: I recovered enough tonight to go to the shop and put a scandi grind on the new neck knife and make a small kydex sheath. I will have time to finish some orders tomorrow , includung the first Baby Booshway! I will ship Ridge Runners PSK tomorrow. And I promise photos of the new neck knife. These knives will be a joint project between my father -in-law and me. He will cut them out, and profile them close, I will touch up and mark holes, and he will drill, then I will heat treat and grind. Right now I plan on offering them scandi ground, bare handle, with a kydex sheath. Price will be reasonable 65.00 shipped I think. I will catch you guys tomorrow afternoon! :thumbup: Wish me luck in Spanish 001 ! :D
 
m. wohlwend said:
I got up early, and went to my first day of classes. I had been on the waiting list, but people didn't show up, so I scored all 3 classes I needed. I then rode my bike, and pushed it real hard (25mph) for a few miles. That put my blood sugar down to 66! :eek: I recovered enough tonight to go to the shop and put a scandi grind on the new neck knife and make a small kydex sheath. I will have time to finish some orders tomorrow , includung the first Baby Booshway! I will ship Ridge Runners PSK tomorrow. And I promise photos of the new neck knife. These knives will be a joint project between my father -in-law and me. He will cut them out, and profile them close, I will touch up and mark holes, and he will drill, then I will heat treat and grind. Right now I plan on offering them scandi ground, bare handle, with a kydex sheath. Price will be reasonable 65.00 shipped I think. I will catch you guys tomorrow afternoon! :thumbup: Wish me luck in Spanish 001 ! :D
Click to expand...

Excellent! Though I loath Spanish class. I was terrible at learning it.

I sent you an email, check it out. I hope it does not interfere with you new class schedule.
 
C Bryant said:
Excellent! Though I loath Spanish class. I was terrible at learning it.

I sent you an email, check it out. I hope it does not interfere with you new class schedule.
Click to expand...

We are good! I will be out of class when you want to drop by :thumbup:
 
Knifepictures113.jpg


Top : PSK
Middle : New neck knife
Bottom: Altiods tin knife

Knifepictures112.jpg


Knifepictures111.jpg


We will get a small run of these up soon....
 
very nice Mark... i like the looks of that a lot and i think i might have to grab one too..:D
 
Last edited:
You must log in or register to reply here.
Back
Top