- Joined
- Nov 24, 2005
- Messages
- 10,038
I walked outside for a second and my RC-3 Mil was sitting by the door. Outstanding! 
That said I immeditely tore it apart for inspection and the knife is a beauty. I had hoped to EDC it in place of my Izula but I have an issue that needs resolution before I can do that the way I'd like to.
In another thread a member was kind enough to show his sheath attached to his pocket with the included pocket/IWB/Boot clip. That was my intention as well.
Unfortunately my clip attachment will not mate with the sheath. On the back of the clip attachment, where the clip retaining plate rests, it's 1/16th of an inch too high and the holes won't line up to screw it to the sheath.
I had thought about taking a dremmel and grinding away at the top so it would slide up and mate correctly but it looks like the whole clip will be cut in half if I take a 1/6th off the top (where it goes through from the back retainer to the actual clip).
Any advice is welcome! Thanks

That said I immeditely tore it apart for inspection and the knife is a beauty. I had hoped to EDC it in place of my Izula but I have an issue that needs resolution before I can do that the way I'd like to.
In another thread a member was kind enough to show his sheath attached to his pocket with the included pocket/IWB/Boot clip. That was my intention as well.
Unfortunately my clip attachment will not mate with the sheath. On the back of the clip attachment, where the clip retaining plate rests, it's 1/16th of an inch too high and the holes won't line up to screw it to the sheath.
I had thought about taking a dremmel and grinding away at the top so it would slide up and mate correctly but it looks like the whole clip will be cut in half if I take a 1/6th off the top (where it goes through from the back retainer to the actual clip).
Any advice is welcome! Thanks
