- Joined
- May 2, 2004
- Messages
- 6,848
When the motor is this large, people are bound to ask; "how many horse power is that motor"? I figure, if I paint the HP on the thing, people wont have to ask. 
I know it was hell on my back getting it in place.
83 pounds
It was good of them, too put lifting rings in the top.:thumbup: That made it a bit easier.
I installed a 6 inch drive wheel also.
I love it :thumbup:
On the highest speed, it sounds like; this is where its supposed to run.
The three speeds are: 5250----2600----1250 SFM respectively.
With the added power; You can work at much lighter pressures. The metal comes off fast.
Wanted to share "my new toy", as the wife puts it
It was well worth the effort, Fred

I know it was hell on my back getting it in place.


It was good of them, too put lifting rings in the top.:thumbup: That made it a bit easier.

I installed a 6 inch drive wheel also.
I love it :thumbup:

On the highest speed, it sounds like; this is where its supposed to run.
The three speeds are: 5250----2600----1250 SFM respectively.
With the added power; You can work at much lighter pressures. The metal comes off fast.

Wanted to share "my new toy", as the wife puts it

It was well worth the effort, Fred
