Old Kershaw

S

Sir_Patrick

Joined
Dec 14, 2002
Messages
20
So im getting ready to go to Iraq and I want to take a Knife that ive had for many years the only issue is that the blade is not what it used to be, I learned how to sharpen knives on a bench grinder and needles to say the blade is much smaller than it used to be was curious on any of your experences on sending back a knife for warrentie repairs. Any responce is much apreciated!
 
I don't see how grinding off too much of the blade would fall under "warranty"? You could contact Kershaw about replacing the blade but I would expect it to be on your dime.
 
Sir_Patrick said:
So im getting ready to go to Iraq and I want to take a Knife that ive had for many years the only issue is that the blade is not what it used to be, I learned how to sharpen knives on a bench grinder and needles to say the blade is much smaller than it used to be was curious on any of your experences on sending back a knife for warrentie repairs. Any responce is much apreciated!
Click to expand...

I doubt it would be covered....you ground metal away with a bench grinder. Why would you expect the manufacturer to cover this under warranty? Would you consider contacting a tire manufacturer to get replacement tires after wearing those down?

If your desire is to have the blade replaced, call Kershaw customer support and ask the question. You said the knife is old so they may or may not be able to replace the blade. If it is a discontinued model, you may be out of luck.
 
They shouldnt cover you imo. I think you should ust buy a new knife or find out about a replacement blade. You may want to learn other sharpening techniques for your next blade ;)
 
yea i figured it wouldent be covered but want sure how much it would cost for a new blade to be attached. Its a Ken Onion Blackout half serated. As for sharpening yes i have found much better ways lol that are easer on the blade. Again it was quite some time ago. Either way thanks for the responces.
 
Because I wanted to take the one that I have had forever, but your right it would be easer to just replace it.
 
I suggest that you quit using a bench grinder to sharpen your knives, the results aren't that great, and it kills your blade as you have noticed. I suggest you contact Kershaw, ask how much you can buy a new blade for, replace the blade, and get a new sharpening technique, like a Sharpmaker because it's a "dummy proof" system and anybody can learn to use it effectively within 20 minutes of practice on crap knives.
 
Send me your addy and I'll send you one , just for kicks and giggles and because you are a loyal Kershaw customer.

Dave
 
You must log in or register to reply here.
Back
Top