Oz Rosie pivot barrel dimension

[CasperAL]

Hi! Does anyone here know the dimension on the pivot barrel on the OZ Machine Company Roosevelt, and where to buy it?

Best,
Casper

 

[celticrogues]

I'm sure the Oz Machine Company would have that info

Seriously though I think everything is made in house there so they would be the only place to get it.

 

[CasperAL]

Yeah, I bet, but they are so late to reply You’re probably right though. I will wait for their answer.

 

[Hyesouljah]

Here’s the answer you’re looking for

Roosevelt Screw Set - Satin Finish (1 set of 7 screws)

Set Includes: 4 Backspacer Screws (size: 2-56 x .125) 1 Clip Screw (size: 2-56 x .165) 2 Low-Profile Pivot Screws (size: 6-40 x .180) These screws are completely made in house on our Swiss lathe. Every screw is T8 with a chamfer on the torx to keep them looking fresh after many takedowns...

ozmachinecompany.com

 

[Sharpoholic]

Here’s the answer you’re looking for

Roosevelt Screw Set - Satin Finish (1 set of 7 screws)

Set Includes: 4 Backspacer Screws (size: 2-56 x .125) 1 Clip Screw (size: 2-56 x .165) 2 Low-Profile Pivot Screws (size: 6-40 x .180) These screws are completely made in house on our Swiss lathe. Every screw is T8 with a chamfer on the torx to keep them looking fresh after many takedowns...

ozmachinecompany.com

Op needs the steel pivot barrel, that the 2 titanium pivot screws thread into. What you linked is just the screws.

C CasperAL Best way to figure it out is to ask the manufacturer through email.

 

[Hyesouljah]

Op needs the steel pivot barrel, that the 2 titanium pivot screws thread into. What you linked is just the screws.

C CasperAL Best way to figure it out is to ask the manufacturer through email.

Whoops. Good catch. Yeah, email Daniel in that case or join his Facebook group and ask in there. I’m positive someone will have an answer in the OMC Facebook group