Para2 clip screws..

D

Dr Heelhook

Joined
Jul 24, 2007
Messages
3,285
The top clip screw of my Para-Military2 fell off and I need a new one.
I noticed that the clip was wiggling back and forth and the screws were getting looser, but didn't pay much attention to it, then one day one of the screws was gone. I tried to replace it temporarily with the top screw of my old waved Endura4, but they didn't match, the Para2 one is of a wider variety. I was surprised, since the two clips are seemingly identical (except for color.) I was thinking about mailing Knifecenter and ask if they have any spare ones for the Para2 to go with my next order from them. Then again I really doubt that they do, since the Para2 is hard to come by as it is. Does anyone know if there are any other Spyderco knives that do have the exact same clip screws, so that can ask for some spare ones for that knife instead? Or does anyone have any other ideas?
 
Only way to find out is to call or probably better for the OP, send an email. They do respond to emails pretty quickly.

They might send some out for free but I know that they want about 5 bucks for a replacement clip and almost another 5 bucks to ship it. It made me pretty mad so the Salt 1 that needs a clip sits in a drawer because I didn't really want to pay 20% of the cost of the knife at the time. Especially when it could be stuck in an envelop with a 44 cent stamp. But I have also heard that out of country customers sometimes get a little better service.
 
2-56 size screws. Kershaw, Benchmade, Buck, Spyderco, Emerson and more all use them. Pick a USA made knife it should fit. Length may be different so if too long it could affect the pivot and/or washer if you carry tip down or it could stick out far enough to possibly ding the edge if tip up so check for those things.

STR
 
You must log in or register to reply here.
Back
Top