- Joined
- Oct 4, 2010
- Messages
- 256
This is one of my Phat Boy locking liner folders and its destined for The Blade Show. My table is 5-M,up front in The Guild Section.
The blade is Sandvik 14C28N stainless steel @59 Rc,1/8"x2 3/4",flat ground with a 120 grit silicon carbide blasted finish. It pivots on a 1/8" stainless steel pin and bronze washers.
The liners are .05" titanium with a jeweled finish inside.
The bolsters are 1/8" titanium blasted with 120 grit silicon carbide.
The scales are carbon fiber with a blasted finish.
The spacers are 1/4" diameter 416 stainless steel also blasted with the silicon carbide.
The cantilevered thumb stud is made of 440-C stainless steel and blasted with the 120 grit silicon carbide.
All the screws are alloy steel with a black oxide finish.
I like the dark finish that the silicon carbide gives the parts that are blasted with it,I call it the Zinker effect since Brad Zinker told me how to do it.
Questions,comments and constructive criticsism welcomed.
Y'all enjoy!
The blade is Sandvik 14C28N stainless steel @59 Rc,1/8"x2 3/4",flat ground with a 120 grit silicon carbide blasted finish. It pivots on a 1/8" stainless steel pin and bronze washers.
The liners are .05" titanium with a jeweled finish inside.
The bolsters are 1/8" titanium blasted with 120 grit silicon carbide.
The scales are carbon fiber with a blasted finish.
The spacers are 1/4" diameter 416 stainless steel also blasted with the silicon carbide.
The cantilevered thumb stud is made of 440-C stainless steel and blasted with the 120 grit silicon carbide.
All the screws are alloy steel with a black oxide finish.
I like the dark finish that the silicon carbide gives the parts that are blasted with it,I call it the Zinker effect since Brad Zinker told me how to do it.
Questions,comments and constructive criticsism welcomed.
Y'all enjoy!
