PM2 Screws

T

tsiloics

Joined
Feb 4, 2006
Messages
1,175
Does anyone know of a source for PM2 pivot and stand-off screws? I emailed Spyderco, but got no response.

Thanks
 
Give them a couple days. They'll get back to you. Last month it took them a couple days to respond. Training new staff or something. They came through though, as usual. If you're in a huge hurry, try phoning.
Good luck.
 
Rusty_shackelford said:
Give them a couple days. They'll get back to you. Last month it took them a couple days to respond. Training new staff or something. They came through though, as usual. If you're in a huge hurry, try phoning.
Good luck.
Click to expand...
do they even give out hardware though?
 
Mo2 said:
do they even give out hardware though?
Click to expand...
I've been charged and I've been sent free hardware.
I was looking for a pocket clip for a discontinued model and they charged me $5ish.
I've been sent free hardware a few times. Pm2, military, and delica if I remember correctly.
Id say expect to pay a couple bucks. If you get it for free it's a bonus.
 
TazKristi posted on their site's forum today or yesterday that much of the crew is preparing to go to some show, so a response may be a bit delayed.
 
tsiloics said:
Does anyone know of a source for PM2 pivot and stand-off screws? I emailed Spyderco, but got no response.

Thanks
Click to expand...
Forget e-mail. Call them, they will ask for a picture of the knife missing the screws and will tell you that they only send screws once every 10 days. They will arrive.
 
^ this, IMO the best and the quickest way! I've done this a couple of times on stripped pivot screws having had messed one up myself on my PM2 and also having had received a messed up one on a previously used Slysz Bowie. Both times emailed photos as requested and a bout a week or so later on, I received two brand new pivot screws free of any charges. Spyderco is an extremely professional and CS oriented outfit for a larger production knife Co.
 
Will they do the same for lanyard tubes now that they are condoning disassembly by switching to medium loctite??? I had to replace a mangled one, but would like a stock tube.
 
You must log in or register to reply here.
Back
Top