Pocket clip

[seth.vanfossen]

What the best way to tighten my pocket clip on my ontario rat 1 so it stays in my pocket better

 

[Spyder328]

Take the clip off then bend it and put it back on :thumbup:

 

[VictorLouis]

Correct. I use two sets of small pliers, both needle-nose. grip on either side of the primary bend and close that up slightly. You want to err on the side of too LITTLE 'oomph' at first, rather than too much. Then, re-attach it to the knife with at least two screws for stability, and check the tension on your pocket. If it's still not to your liking, repeat with a bit more oomph.

 

[Sonnydaze]

I take off the clip and put the "attachment end" in my bench-vise; bend it a little with your fingers. Mount it on the knife to check. Repeat as necessary.

 

[Capt. Spaulding]

I just take it off and bend it with my hands. Re install and your good to go.

 

[CairoBeretta]

The clip on my Rat 1 has been great. Love this knife, I've been flicking it for the last two hours while I watch a movie...