Polishing Bevels

[AbLonewolf]

So a quick question:
When you get to the final phases of polishing your bevels with a 2X72 grinder using higher grits, what percentage do you set your VFD at? Thank you.

 

[Alex Topfer]

It's going to depend on your final grit, the belts you're using, and the exact speed your grinder runs at. You'll need to play with your setup
I only grind up to 120, so i may slow it down to 80% but not always. My grinder is pretty low speed though.

 

[DevinT]

The finer the belt the slower the speed. A flat platen will be slower than a contact wheel.

Hoss